Serving the Central Valley, the Bay Area and Sacramento
CSLB #247684 · Since 1967 (209) 652-9206
Hydro Blasting in Riverbank, CA
Our Services

Hydro Blasting in Riverbank, CA

Hydro Blasting · Riverbank, CA

Hydro blasting with water at 40,000 psi

Hydro blasting strips adhesive and coatings off concrete using water at 40,000 psi. We run the unit on site across the Central Valley, the Bay Area and Sacramento. That includes hydro blasting in Modesto and the towns nearby. Water alone does the cutting, so there is no sand and no chemical in the mix.

The family has run this company since 1967. It started as a homebuilder, then spent decades in flooring. Today we work in environmental and demolition under CSLB #247684 and CAL OSHA #507. Floors are still where most of our hydro blasting work lands.

What We Handle

  • Adhesive and mastic removal from concrete
  • Epoxy and urethane coating removal
  • UHP water blasting at 40,000 psi
  • Full HEPA vacuum water and debris recovery
  • Concrete surface profiling for new coatings
  • Paint and sealer stripping off slabs
  • Loading docks, ramps and equipment pads cleaned
  • Asbestos floor mastic removal using water

Free Hydro Blasting Estimate

Tell us about the job and we’ll get right back to you.

How does hydro blasting work?

Hydro blasting uses a pump that pushes plain water up to 40,000 psi. At that pressure the stream cuts adhesive, coating and sealer right off the top of the concrete. The head rides on the slab and works in overlapping passes, much the way a floor grinder does. Nothing hard is thrown at the surface, so the sound concrete underneath the coating is left alone. The water and everything it lifts go into the HEPA vacuum built into the same unit.

The vacuum runs off that same unit and pulls the slurry up as fast as the head makes it. Floors come up damp rather than flooded, and the spent water is captured as we go. Because there is no dry dust in the air, the space next door can stay open. That recovery is what makes hydro blasting workable in a building that is still in use. Other trades can keep going on their own scope while we run the floor.

What hydro blasting takes off concrete

Most hydro blasting calls are about something stuck to a slab. Carpet glue, tile mastic, black cutback adhesive and floor paint all come off with the water. So do epoxy and urethane coatings, plus the sealer on an older warehouse floor. Where the floor covering has to come up first, that is our flooring removal and surface preparation work. What is left is a slab with an open profile that a new coating can grab.

Hydro blasting also cleans concrete ramps, loading docks and equipment pads, since the water lifts oil, paint and sealer and leaves the slab sound. On stucco, block, brick and painted masonry an abrasive usually moves faster on the same square footage. That is our sand and slurry blasting work, and it runs on lifts and scaffold outside. Sometimes both tools run on one building, one on the walls and one on the floor. Send a photo of the slab and what is on it, and we can tell you which fits.

Who hires us for hydro blasting

Property owners call us when a floor has to be stripped before a remodel or a sale. General contractors bring us in on tenant improvements, where the slab has to be clean for the next trade. Facility managers use hydro blasting in warehouses, kitchens, gyms and retail floors that have to keep running. Coating installers hire us for the profile, since a new epoxy only holds on a clean, open slab. Schools, hospitals, offices and stores are typical settings, because the work stays wet and stays inside the tape.

A job starts with a free estimate, and we come out and look at the slab in person. We check what is on it, how thick the layer runs, and where water and power come from. On the day, we set plastic and tape at the openings so the wet work stays in one room. The hydro blasting unit works its passes while the vacuum takes the water and debris as they lift. The spent water and debris leave with the recovery unit, and the slab is swept and handed back.

UHP water blasting head working across a concrete slab during surface preparation Concrete slab with old adhesive stripped clean by hydro blasting, untouched mastic beside it

Ready to get started?

Free, no-obligation estimates across the Central Valley, the Bay Area and Sacramento.

(209) 652-9206
See It Run

See the Work Up Close

UHP water blasting at 40,000 psi stripping floor adhesive with HEPA vacuum recovery, no dust and no chemicals.
What You Can Expect

How a Job With Riverbank Runs

From the first call to the last load hauled off, here is exactly how it goes.

1

Call or Send the Form

Tell us what needs to come down or come out, and where the property is. You talk to the people who run the work, not a call center.

2

Site Visit and Real Number

We walk the job, check access and materials, and flag anything that needs an asbestos survey first. The estimate is free and it holds.

3

Permits and Prep

Demolition permits, air district notifications, utility disconnects: we handle the paperwork phase and tell you what the schedule looks like.

4

Demo, Haul-Off, Clean Site

The crew does the work, debris gets hauled to the right facilities, and you get a site that is ready for whatever comes next.

FAQ

Hydro Blasting Questions, Answered

Common questions about hydro blasting across the Central Valley, the Bay Area and Sacramento. If yours is not here, call and ask.

Call (209) 652-9206

Will hydro blasting damage my concrete slab?
No, because the water works on what is bonded to the slab and stops at sound concrete. Only water hits the surface, so the concrete itself stays whole. We set the pressure and the pass speed to match the coating that is coming off. What you get back is a clean floor with an open profile for the next coat.
Can hydro blasting take off asbestos floor mastic?
Yes, and the recovery system is the reason it suits that job. The water and the mastic go into the vacuum instead of into the air. The removal runs under the same rules as the rest of our asbestos removal and abatement work. Cal/OSHA registration applies once the job hits 100 square feet, and a certified consultant takes the samples first.
Do I have to close the building while you work?
Usually not, since hydro blasting makes no dry dust and the water is caught right at the head. We tape plastic at the openings and keep the wet work inside the area we are on. Most jobs run with the rest of the building open for business the whole time. Tell us which areas have to stay open and we will plan the passes around them.
What is left on the floor when you finish?
A bare, damp slab with a rough profile the next coating can bite into. The adhesive, paint or sealer is gone, and the spent water leaves the site with the recovery unit. Concrete dries on its own, and how fast depends on the room and the air moving through it. Your coating installer can check the moisture on the slab before the first coat goes down.
Where do you do hydro blasting?
We cover the Central Valley, the Bay Area, Sacramento and Santa Cruz. Bay Area work runs from San Jose up through the East Bay and out to the Peninsula. Valley jobs cover Modesto, Turlock, Stockton and the towns between them. Call (209) 652-9206 with the address and what is on the floor for a free estimate.
More From Riverbank

Explore Our Other Services

Asbestos Removal in Riverbank, CA

Asbestos Removal

We handle asbestos removal and abatement for homes and commercial buildings across Northern California. Work runs under sealed containment with negative air machines, and the waste goes to a landfill approved to take it.

Residential Demolition in Riverbank, CA

Residential Demolition

We handle residential demolition across Northern California. That covers whole houses, garages, sheds, and mobile homes. Work starts with an asbestos survey and permits, then the teardown and haul-off. A family company since 1967.

Commercial Demolition in Riverbank, CA

Commercial Demolition

Commercial demolition for retail buildings, small offices, warehouses and ag structures. We handle the asbestos abatement, the utility cuts, the teardown and the debris loads. Buildings up to two or three stories are our size range.

Interior Demolition in Riverbank, CA

Interior Demolition

Interior demolition for remodels and tenant improvements across the Central Valley and Bay Area. We gut spaces down to the studs and hand back a clean shell your builder can start in.

Concrete Demolition in Riverbank, CA

Concrete Demolition

We break out and haul away old concrete. Driveways, garage slabs, patios, walkways, foundations and footings all come out the same way. Broken concrete goes to a recycling yard and gets crushed into base rock.

Fire Damage Cleanup in Riverbank, CA

Fire Damage Cleanup

Fire damage cleanup starts once the fire is out and the building is cold. We take down burned structures and haul the debris to permitted disposal sites. The lot is left clear for your rebuild contractor.

Why Choose Riverbank

Why Property Owners and Contractors Call Us

Licensed for the Hard Part

Asbestos is where demolition jobs go sideways. We carry CSLB #247684 and CAL OSHA #507, so the abatement and the teardown run under one contractor instead of two schedules.

Since 1967

The company started as a homebuilder in 1967. Decades of flooring work came next, and demolition grew out of it. The same family still runs the company.

Valley to the Bay

We cover the Central Valley, the Bay Area, Sacramento and Santa Cruz. Modesto, Stockton, San Jose, San Francisco and the cities between them are all regular runs.

Free Estimates That Hold

We price after looking at the building, the access and the survey. You get a real number before work starts, and the paperwork for every load when it ends.

Guides & Resources

Hydro Blasting Guides

Ready to Clear the Way?

Get In Touch With Riverbank Environmental & Demolition

A building that needs to come down, a space to gut, asbestos in the survey, or a fire to clean up after? Call or send the form. We look at the property, price the job in person, and give you a number that holds. Estimates are free.

  • (209) 652-9206
  • 3131 Atchison Street, Riverbank, CA 95367
  • Serving the Central Valley, the Bay Area and Sacramento
  • CSLB #247684 · CAL OSHA #507 · Since 1967

Get a Free Estimate

Tell us about the job and we’ll get right back to you.

Call (209) 652-9206